DFM Report

DFM/DFT/DFX Services

In order to reduce the possiblities of repair and defects and ensure production quality, our support services team will provide DFM/DFT/DFX support services in highly knowledgeable and experienced ways. We don’t transfer any obvious risk to customer.

 

DFM (Design for Manufacturability Analysis)

Completely check of customer design drafts including FAB circuit/trace routing, component positioning and spacing, potential fault reduction and process selection, and also provide proposal to promote customer’s design (circuit design, mechanical design, etc). This service plays a huge role at the early stage of volume production.

 

DFT (Design for Testability Analysis)

Throughly review of the circuit design, trace routing to increase test accessibility and device testability to increase the overall coverage over Flying Probe Test and In-Circuit-Test, with main purpose of getting the lowest possible risk and best product yield rate in the volume production stage.

 

DFM/DFT review for Product Design

DFX report will be sent to customer for new PCBA assembly project. Our report will cover the index:PCB layouts, component packages, assembly processing, test plan. Additional suggestions include major procedures or functional problems, cost saving methods, process improvement proposal.

 

DFM is the initial stage of PCB design phases, but more crucial for PCB design.

Contact NOD Electronics Now!

Contact Us

Get answers from a reliable PCBA partner in as little as 12 hours. Start enjoy 5-star electronic manufacturing services (including PCB manufacturing, PCB assembly, circuit board assembly, test, box build and logistics) right now.

NOD Electronics - PCBA - PCBA Assembly Services

Address: Block 3, #20-8 Huanxi West Rd, Tianhe, Guangzhou 510660, China

Mobile: +86-1682-0101-507

E-Mail: sales@nod-pcba.com

Tel: +86-020-82515913