What happens when components are too close to the fasteners?

What happens when components are too close to the fasteners?

Publish Date:2019-11-18 16:29:47 Clicks: 243

What-happens-when-components-are-too-close-to-the-fasteners.jpg

  • BGA layout should be at least 5mm away from the screw to avoid the BGA corner close to the screw. The BGA is close to the screw, and the solder joint is cracked in the BGA after the PCBA is mounted.

  • The heat sink screw is close to the BGA, causing the solder joint around the BGA to break.

  • The chip capacitor layout is near the charging terminal, screw, button or socket, causing the chip capacitor to crack.



Copyright 2009-2020 All Rights Reserved by NOD Electronics
Building E, Qixing Industrial Area, Xintang Town, Zengcheng District, Guangzhou 511340, China
Powered by MetInfo 7.2.0 ©2008-2023  mituo.cn